SyncFolder Mobile Sync

This location type โ€” SyncFolder Mobile Sync (Android) โ€” connects over Wi-Fi to an Android device running the SyncFolder app with its Mobile Sync Server started. The server makes the folders you shared on the phone available to the Windows app. Mobile Sync can be used as source, destination, and in 2-way sync tasks.

After selecting this type and clicking Select drive/folder, the Select Mobile Sync device popup opens.

Before You Start

  • Install the SyncFolder app on the Android device.
  • In the Android app, open the Mobile Sync Server page, choose the folders to share, set a user name and password, and start the server. See the mobile user guide.
  • Make sure the PC and the phone are on the same Wi-Fi network.

Finding and Connecting to the Device

  1. The popup searches the local network for devices with an active Mobile Sync server. Make sure SyncFolder is open on your mobile device and the server is active on the same Wi-Fi network.
  2. Select your device in the list. It can take a couple of seconds before a device is discovered.
  3. To connect, enter the password configured on the mobile device and click Connect.
  4. SyncFolder then shows the Configured folders โ€” i.e. the folders shared on the phone. Browse to the desired folder and click Select folder.

Pairing with a QR Code

On some networks โ€” for example mesh Wi-Fi systems, guest networks, or routers that block multicast traffic โ€” the mobile device doesn't show up in the list automatically. Pair the device then with a QR code instead:

  1. In the popup, click Show QR code ("Device doesn't show up? Click 'Show QR code' to allow the mobile SyncFolder app to pair with the PC after scanning the QR code.").
  2. On the mobile device: make sure that the Mobile Sync Server page is open and the server is started. Then, scan the QR code on your PC screen.
  3. The popup shows Pairing successful via QR code. Enter the password and click Connect.

The QR code is valid for a short time. When it expires, the popup shows "QR code expired. Click 'Show QR code' to try again." Click Back to device list if you want to return to the list of discovered devices.

After pairing, SyncFolder remembers the device. When the task runs later and the phone can't be found on the local network directly, SyncFolder can still locate it through a secure SyncFolder internet service that only exchanges address information. This works as long as the Mobile Sync server is running and Device discovery is on in the Android app's settings (it is switched on automatically when you pair with a QR code).

When the Task Runs

The Mobile Sync server must be running on the phone and the phone must be on the same network. If the device can't be found, the task fails with "Mobile device could not be found using โ€ฆ". Open the SyncFolder app on the phone, start the server, and run the task again.

The password and the shared folders are configured on the phone, in the Android app โ€” not on the Windows side. If the shared folder of a task was removed on the phone, SyncFolder reports "The configured folder no longer exists on the server: โ€ฆ".

This guide covers Windows tasks that use the phone as storage. To let the Android app use your PC as storage, see Mobile Access and Sharing and Working with the Android App.